Further explanation

This is an additional management method in addition to the scheduling execution method.

  • There is an emergency stop button on the back of the robot

  • When the button is pressed, the led flashes in red, and the robot can be moved easily by pushing it.

  • E-stop mode can be disengaged by turning the button

  • The case can be opened by pulling the rear hook.

  • If discharged inevitably,

  • Open the case and take out the charging cable.

  • You can manually charge the battery by plugging it into the connector on the right side of the station.

Actions in case of other problems

  • If the robot runs out of the designated route or place, turn off the robot, move it to the starting position, and then turn on the power.
  • If the robot is stationary for a long time, run a few laps around the robot. If it still remains stationary, power off the robot, move it to the starting position, and power it on.
  • If something goes wrong while the station is charging, press the e-stop button to slowly pull the robot back and then turn off the power.